3 Easy And Affordable Ways To Unclog A Stubborn Drain

Clogged drains are a fact of life, but they can also be a pretty expensive annoyance when you're unable to get the water flowing again with a simple plunger. Sometimes, there's nothing you can do other than call the plumber. However, sometimes you just haven't tried the right DIY method. Unless you've lost something valuable down the drain and don't want to risk harming or losing it, it's worth trying one or more of these methods before you call a plumber. You to  may be surprised by your ability to unclog a drain once you find a method that works for your particular clog. The following unclogging methods are simple, non-messy, and surprisingly effective.

The Boiling Water Method

This is hands-down the simplest method of unclogging a drain and it works especially well for unclogging kitchen sinks backed up because of food debris. Just boil a large pot of water and pour it down the drain. Go slowly, and pour it down the drain in several stages. Let one batch of water work its way through the drain before pouring the next batch, and keep going until the sink is draining freely.

The hot water helps break down and dissolve food particles stuck together and blocking the drain, and it can also temporarily melt grease hardened inside of the pipes, allowing it to flow through your plumbing system. No chemicals or tools required.

The Chemical Reaction Method

When you think of chemicals and drain cleaning, you probably think of the commercial drain cleaners you can buy in the store. However, those are not always the best choice. The caustic chemicals in the drain cleaners can be bad for your local environment, and if you use them too often, they can be hard on your pipes. Plus, drain cleaners are expensive, and you're trying to find inexpensive solutions to a clogged drain.

You can create a powerful but harmless chemical reaction with enough force to open up your drain with some inexpensive and readily available ingredients. All you need is baking soda and vinegar. Remove as much as the standing water from the sink or tub as possible, and put a few spoonfuls of dry baking soda into the drain. Follow that up by pouring vinegar on top of it. If you've ever built a model volcano for a science project, you'll recognize the reaction that happens next. The combination of the vinegar and baking soda will create a lot of fizz and bubbles, and whatever is clogging the drain should be pushed out of the drain along with the bubbles.

If your drain clog is accompanied by an unpleasant smell, you can use lemon juice instead of vinegar. You'll get the same chemical reaction, but with an agreeable lemon scent to go along with it.

The MacGyver Method

When the clog is very large or very stubborn, you may need a little more power to get the job done. If that's the case, and if you don't mind doing a little tinkering, this method might be right for you. All you need is a shop vac that can handle vacuuming liquids and an old plunger you don't use anymore.

Remove the stick from the plunger. Fit the rubber part of the plunger around the vacuum's wand attachment. You may need to cut the rubber to accomplish this, but make sure you attach it as tightly as possible. If necessary, some duct tape will hold it in place while you unclog the drain.

Set the vacuum to vacuum liquids, and place the wand attachment over the drain, creating a tight seal with the help of the rubber plunger piece. Turn the vacuum up to its highest setting, and with any luck, the suction will draw the clog up out of the drain and into the vacuum bag.

If none of these methods work, you may need a plumber's specialized skills and knowledge to get the water flowing freely through your pipes again. Stagnant water can lead to bad smells and mold, so don't wait – if you can't get rid of the clog yourself, schedule a visit from a plumber as soon as possible. Check out sites like http://calldoctorfixit.com for more information.

Share